|
Step1:Adjust
the different specifications of the product
Turn off
the motor, loosen the lock nut supporting plate, the workpiece size regulating
shaft to move out. Unloading
the upper die and the lower die, the need for the upper and lower die, according
to the following step2
and step3 to
complete the diameter and height of the adjustment.
Step2:Adjust
the workpiece diameter
Loosen
the lock nut supporting plate, the premise of the press wheel does not touch the
head of, (above the head, the first pressing wheel, adjusting the size of the
workpiece axis center of 3.1)
.The
first roller is adjusted to the distance from the top of the head about 2mm,
the
locking nut lock tight to 3 points,
at this
point to turn the handle to see if the distance between the second rollers to
keep up with the pressure head is the same as the distance between the first
roller and the pressure head, if
the distance between the two rollers to keep up with the pressure head is
relatively large, at
this time, we need to use the eccentric shaft to adjust the distance between the
two rollers to keep up with the pressure head,
generally,
the first press wheel is closer to the upper pressure head than the second
pressing wheel. (about 0.5mm), this step is a good and fine adjustment screw
slowly inside adjustment, generally to the first round of pressure head distance
is about 0.5--0.8mm, second wheel head distance is about 0.8--1.2mm, at this
time if a wheel distance is not ideal can be adjusted (by an eccentric shaft
this size depends on the effect) after adjusting the lock nut lock.
Step3:Adjust
the height of the workpiece
Loosen the height adjusting rod nut, adjust the height adjusting screw height,
put them in a jar and lid, will lift the handle into the up position, rotating
head height adjustment screw to just stick the lid and then to increase 1 2mm or
so, to achieve the sealing tank body and the tank cover rotation function, and
then lock the nut can be.
Step4:Test
seal
The above two
steps can be carried out after the test well sealed, open motor switch, put them
in a jar and lid, treading the foot pedal, the right hand to hold the handle in
turn the first roller and the second roller pressure on the head (Note: the
wrench handle when the speed is not too fast, otherwise it will hand to steady,
the edge seal appears choppiness or Flash), when second pressure wheel pressure
head back from around 5--10mm, that is to limit pressure wheel rotation, then
release the pedal, follow the workpiece bottom die in place after the handle
drop back, look at the effect of out products, the effect can be no problem
production, if the result is not ideal and can adjust the eccentric wheel.
|
