|
|
 |
|
White
Wall
Mounted
Loft Wall Ladder
|
|
 |
This loft ladder is made of
high-quality Mg-Al Alloy with wear and rust resistance
characteristics, more durable than ordinary steel. The
special S-shaped strings adopted by the attic access
ladder enhance the bearing capacity, up to 660 lbs.
|
|
Attention |
Before you purchase it, please clearly confirm
SIZE of the product.
The color
is White.
DO NOT
stand under the ladder when you install it.
DO NOT
over load bearing capacity.
Complimentary with
2 spare steps.
|
 |
|
Parameter |
|
Color |
White |
|
Height |
2.5m/8.2 ft |
|
Material |
Aluminum-Magnesium Alloy |
|
Step |
10 |
|
Step Size |
40 x 14 cm /
15.7 x 5.5 in. |
|
Weight Capacity |
660 lb |
|
|
 |
 |
|
Matters needing attention:
1.Please install the fixed frame according to the height on our
website. If the installation height is not appropriate, please
contact us to solve the problem!
2.When pulling down the ladder, do not stretch it backward too
much. Just put it on the ground naturally. Excessive stretching will
cause uneven stress and may cause tilting. If you are not sure about
the stretching position, you can take photos to contact us!
3.If it is used for several months or frequently, you can check
whether the screws are loose as a routine maintenance of the stairs.
4.If there is a fault during use, please contact us first, and do
not repair it yourself to prevent improper maintenance!
|
|
Maintenance Information |
Users are responsible for the proper operation and maintenance of
the equipment they use. Some equipment will quickly become damaged
and unsafe if abused or subjected to improper demands. If equipment
is regularly maintained and not abused, you will get the maximum
safety and service performance from loft wall ladder stairs.
-
Do not overload ladder stairs.
-
Do not knock it vigorously.
-
Do not disassemble it
casually.
-
Do not open the tripod forcibly.
-
Do not play movement on ladder stairs.
These uses create severe impact and shock loads that may lead to
steps and equipment failure.
|
|
Operation Demo |
a) Position the ladder by lifting to the wall
where it has to installed and mark the holes for drilling
location.
b) Drill holes on the concrete block in line with the hole
marking location.
c) Clean the holes free from debris and other foreign particles
after the drilling procedure using an air gun or any similar
equipment.
d) After marking place the ladder in a safe ground position.
|
|
Item Include(022224) |
|
|
|
