Before Using
1.Put the machine smooth
2. Adjust the roll gap, clockwise to tighten and counterclockwise to loose.Starting from the smallest gap, counterclockwise a circle, roll gap increased by 0.06"(1.5 mm).
3.Wash the machine before use (There will be a small amount of rust on the solder joints, clean them and apply vegetable oil to prevent rust.)
4.The food contact part of the machine is 304 stainless steel.
5.If the machine is jammed by sugar cane, cut off the power immediately (to prevent burning the motor)
6.The exterior of the machine has been wiped with anti-rust oil before leaving the factory.6. The casing of the machine has been wiped with anti-rust oil before leaving the factory.
Note :
1- Can't adjust the roll gap too tightly .
2-The ground wires should be attached to the machine.
3-Due to the high power of the motor, the sound may be louder than 750W machine.
4-Because the motor power of the machine is large, the vibration amplitude of the machine will be higher than 750W. After using for a period of time, maintenance needs to check whether the wiring of the machine switch is off, and install bearing lubricants.

Operation Steps
1.Choose the proper power(110v/1500W/60Hz)(Note: Due to the high power of the motor, the sound may be louder than 750W machine)
2.Cut a wedge on the sugarcane before put it into the machine
3. Starting the processing
4.After squeezing finished, you should wash the rollers timely, make sure no sticky in juice box and keep it clean.
5.In older to prevent rust please clean after use.
Packing list :
Tray x 1 Strainer x 1 User Manual x 1
Technical Parameters
Productivity:300 KG/h
Voltage:110V
Frequency:60Hz
Power:1500W
Size(Not including tray ):19.69"*16.93"*31.5"