110V Full Automatic Saw Blade Grinding Machine

1. wheel motor fixed seat
Fixed grinding wheel motor, left and right teeth saw blade  can swing angle (usually around 5 degrees).
2. cross trailing board
The cross carriage can control the wheel motor moving around  and around.
3. saw blade fixed slide plate
First, the fixed seat of the saw blade is installed on the  working table (three screws can not be locked too tightly to  make the fixed seat swing). When the saw blade is installed,  the diameter of the saw blade is placed in different sizes,  and the saw blade can not be pressed too tight, so that the  saw blade can be rotated. The five star handle can adjust  the saw blade to move to the right position before and after  (pushing the thimble on the alloy tooth).
4. electric box control panel
A. governor
The speed of gear grinding can be adjusted by the knob, left  and right, and the speed of grinding is adjusted according  to the need. A switch is below, which can switch the gear  driving motor.
B. counter
Set the number of teeth according to the number of saw  teeth, the method is set by the number of up and down + / -  number, set after the R black spot confirmation, the red  small box is set to *1, each time after the grinding set  tooth number, according to the R black point can be  repeated.
C. total power switch
D. pump water switch
E. stop switch (start switch)
F. thimble pin
G. operating table
H. size teeth locking handle (loose when adjusting, must be  locked after adjusting).
I. size tooth adjusting screw

1. Before starting  grinding, the grinding wheel motor is moved back in order to  avoid the grinding wheel when debugging, and the saw blade  fixed slide plate, the saw blade, the push, the moving  grinding wheel, and the angle of the saw blade according to  the situation.
2. The speed is slowed down to make the tooth surface  parallel to the front and rear side of the table. If not  parallel, it is parallel to the direction of the slide seat  of the sawblade. If it is a positive tooth, the grinding  wheel motor turns to zero, then one tooth pushes, such as  the left and right or left or right 5 degrees, then a tooth  push, and the left tooth grinding right tooth.
3. When the teeth are adjusted, they start to work.  According to the number of teeth, the number of grinding  teeth can be adjusted according to the number of saw teeth,  such as the 60 teeth saw blade will be set to 61 teeth.

• A set of  110V Automatic Saw Blade Grinder