1. PREPARE SCREEN:
Make sure the screen is clean and free of dust and oil, if you want
better effect, you can use asc365 special liquids to get mesh dull for
easier attaching. Spray the screen with water. It should be completely
soaked, but not dripping. Asoyou can
use a spray bottle to wet screen.
2. APPLY
EMULSION TO SCREEN:
Apply the dull/sticky side to the back of the wet screen. You can roll
the emulsion sheet, apply front part, then roll down the whole sheet.
There are two sides to the sheet, one
shiny and one dull. If you can’t tell which is which, wet your fingers
and touch the corner. The sticky side is the dull side.
Run squeegee over the shiny surface of
the emulsion, then another size, the last time is back to shiny surface.
TIP: Inspect front of the screen for
any bubbles or dry areas. Dry areas will have a spiderweb pattern. Use
spray bottle with water to lightly mist any dry areas. If three times is
not good, you can keep squeegeeing both sides of screen to eliminate
excess water prior to drying. As to drying, you can use hair dryer,
because of mesh humidity, environment, and dryer power, distance to
screen, here we suggest 10-20 minutes, and for better result, you can
choose our special drying cabinet, setting time is 20-30mins,temperature
is 50℃(122℉).After emulsion has dried, remove plastic film. |
