Electronic Dog Fence（Total length of wire 30m）

WARNING：
1, the dog is only for dogs.

2, low battery may cause intermittent operation. Do not use when you feel low.

3, let your dog adapt to the collar before you start training. You should allow your dog to accept the collar as a part of her life.

4, Do not let the collar receiver over your pet for more than 12 hours a day.

5, when the collar in your dog, do not set the program.

6, electronic dog only for use under the supervision of the dog owner.

7, away from children can touch the place.

8,The total length of the fence wire is 30 meters.Do not wrap the wire several times in the enclosed space when using.Otherwise, it will burn out the host machine.

9, Please read all instructions before using this product.

Description::
1.Progressive Tone Stimulus- A warning tone will be issued first, then a shock stimulus if your dog continues to move closer to the boundary
2.Pulsed Proportional Stimulus - The closer your pet gets to the boundary, the more intense the shock
3.Power Boost Switch -The width of the warning can be adjusted by field width adjustment knob in the transmitter
4.Audio Wire Break Alarm- The system's control center has an audible alarm to alert you if it senses a break in the wire or if the boundary system is not functioning correctly
5.Speed Detect Anti-Run Through- The faster your dog is moving, the quicker the higher level of intensity is issued
6.Visual Wire Break Alarm- The system's control center will light alsoup if it senses a break in the wire
7.Quick Disconnect Terminals - quick and secure connection or disconnection of the wire to the control center
8.Low Battery Indicator - When the light on the collar is green, it is working properly
9.Red it means time to replace the battery

How it works:
1) Wall-mounted transmitter: Transmitter is the central controller to whole electronic system. Make sure the wire is set to a loop.
2) The receiver collar: Receiver (collar) will make a warning beep firstly and then continuous stimulation if your dog attempts to approach wire boundary.
3) How to install the system
*Design your containment area and calculate the amount of wire needed.
*Install the wall transmitter.
*Lay out the perimeter wire.
*Connect the perimeter wire to the wall transmitter.
*Verify transmitter is functioning without problem.
*Set up the receiver and then, test the containment system and adjust the field width.
*Install the boundary wire and training flags.
*Fit collars to your dogs and train your dogs.

Item included:

1set of Electronic Dog Fence(053048)